[. . . ] Position the AUX switch to the left or the right to illuminate the red front indicator LED (Fig. 1, #6). This position should also illuminate the red LED on board the Dig Unit. [. . . ] To benefit from all of the technical features of The Dig, PLEASE READ ALL INSTRUCTIONS BEFORE OPERATION FIGURE 1 1 2 3 4 7 8 ­ ­ ­ ­ + + + + S S S S It is recommended to disconnect the red wire from one of the ESC signal harnesses and use the switches for both the front and rear ESCs. Connect the signal harness from the front ESC to the front output (Fig. Referring to Figure 1, the blue LED corresponds to #5 and the red LED corresponds to #6. (FIGURE 2) ONE-TOUCH PROGRAMMING Before programming Novak's One-Touch Setup for the Dig Unit, both front and rear ESCs need to be set up either simultaneously or individually. Be sure to follow manufacturer's set-up procedures for the ESCs carefully. Before turning on your vehicle's electronics, make sure that your transmitter's throttle position and the AUX switch or dial are both in the NEUTRAL position. CONTINUE TO HOLD the Dig's One-Touch button UNTIL THE RED LED TURNS ON, releasing the button AS SOON AS THE LED TURNS RED. Move the AUX switch or dial to one end position, and hold it there until the green status LED TURNS SOLID GREEN. Move the AUX switch or dial to the opposite end position, and hold it there until the green status LED BLINKS GREEN. Return the AUX switch or dial to NEUTRAL. THE DIG SETUP PHOTO Refer to Figure 1 for the following steps. A three-position switch or dial control is required to operate the Dig Unit. [. . . ] · The Dig: Electronic Dig Unit for Dual System Crawlers is a trademark of Novak Electronics, Inc. ­ + HARNESS INSTRUCTIONS TRANSMITTER ADJUSTMENTS ­ + 5 6 1. 2) input from receiver Output to rear ESC Output to front ESC LED harness indicator (blue) for rear ESC LED harness indicator (red) for front ESC On-board (red) LED indicator for front ESC (also used with One-Touch Set-Up) 8. [. . . ]